Although you can use any towel, your best option is a microfiber towel, which will cause less frizz. This will prevent unnecessary tugging at the roots of your hair.
Typically, all you need to do is rub a pea-sized amount of the lotion or conditioner between your hands and work it in from the ends of your hair to the mid-shaft. Sprays will require you to spray the length of your hair.
It is easier to brush waves into your hair when you start with the lower sections and work your way to the upper sections. This will give the illusion of layered waves.
If you have thick hair, work in sections smaller than the barrel to ensure that each section of hair is styled properly.
Be careful not to burn your hair or skin while doing this.
To avoid burning your hair, make this a fluid and connected motion to when you first set the curl with the blow-dryer.
Be careful to not wind your hair too tightly around the round brush; otherwise, it might tangle.
Do this style on damp hair if you want tighter, more defined waves. If your hair is dry, it’ll create loose, subtle waves.
Continue to use the wide-toothed comb to untangle the rest of your hair as needed. The comb will be able to work out any knots in your hair better than the soft-bristled brush will.
Just make sure to loosely braid your hair so that it is comfortable for you to sleep on.
You may not need a hair tie if you have curly or textured hair. If you have particularly thick or short hair, then divide your hair vertically down the back of your head to create 2 medium braids along each side of your head. For extremely tight waves or crimped hair, section your hair as needed to create small braids that are about 1⁄2 in (1. 3 cm) wide.
This method of waving your hair is great if you want to avoid using a blow-dryer to style it.
If you come across a tangle or small knot while unbraiding your hair, use your fingers to gently comb it out. If your hair was damp before you braided it and still seems a bit damp when you wake up, then use the heat from your blow-dryer to dry the braid. Then, set the shape using the cool function on the blow-dryer. Unbraiding damp hair may cause the waves to flatten.
If needed, use your wide-tooth comb or a hair pick to break up the strands. Just do not comb them fully.
This hairstyle works best if you have short, curly hair.
Make sure to thoroughly rinse out the products from your hair, as the residue from the shampoo or conditioner may make it more difficult to style your hair.
Avoid using products that are primarily made with petroleum jelly, as this can cause skin irritation or acne over the time it will take to grow out the waves in your hair.
Continue to squeeze the towel until it is damp and is no longer dripping wet.
After 2 minutes, remove the towel from your head.
For the back of your head, brush downwards from your circular cowlick. The back of your head may require more attention than the top or sides of your head, as this section of hair is most likely thicker. Make sure to brush this section of hair thoroughly. For the top of your head, start at the front of the cowlick and brush forwards to your hairline by your forehead. For the sides of your head, start at the cowlick and angle your brush stroke forward along the side of your head but at a downwards angle to your chin.
If you do not have a do-rag, you can also wear a skullcap or a special wave cap. However, keep in mind that a skullcap will be less effective for maintaining your style.
If needed, you can purchase a special wave shampoo and conditioner that will allow you to gently wash your hair without damaging your waves. However, you will need to brush out your hair while in the shower if you choose to do this. [18] X Research source
Sometimes, it may take longer than 3 weeks to properly set the waves. Continue maintaining the waves until you have achieved your desired look. Instead of adding more wave product to your hair, you can simply dampen it with hot water.
